Glue Film Iron On Hot Melt Adhesive
From: £0.95
Glue Film
We recommend only using glue film with top quality and flat wood veneer.
This is essentially a hot melt EVA adhesive, supplied on thin film backing paper. Extremely convenient for veneering and where a thin coating of glue is required, especially onto MDF or plywood.
Also for use with plastics, foam, fabrics and leather. Can be cut using scissors or a craft knife.
It melts at a relatively low temperature of around 85°C to 90°C. Heat can be applied from an iron, hot air blower, heated press etc. Apply by either peeling off the paper and laying in position or tack into position by applying heat through the backing paper.
- View our Glue Film Heat Activated Guide here.
- This information is based on our experience. It is intended as a general guide and recommendation. It is not a warranty or specification. Before use, we advise customers test and determine that the material is suitable for their intended purpose.
Approximate thickness of the glue film (excludes backing paper): 0.14mm
Our glue film is 105cm wide, so you’ll receive slightly more than the whole square metre (this doesn’t apply to off cuts and seconds).
Inlay Brass Strip Suppliers, Brass Rod, Brass Rod Suppliers, Brass Bar.
Additional information
Size | All measurements are approximate. |
---|
Only logged in customers who have purchased this product may leave a review.
Reviews
There are no reviews yet.